At present, the lifting belt market is more mature, and the quality of the brand lifting belt of big manufacturers is basically guaranteed, except for some small workshops. Before, a customer gave feedback on such a problem and questioned the quality of the lifting belt. Later, after testing, it was found that there was no quality problem with the lifting belt, but it was cut off in the process of lifting operation. For such things, it is necessary to reiterate the correct use of the lifting belt.
Lifting belt before leaving the factory is to go through strict testing links, but no matter how good the quality of the lifting belt also needs to be safe under standard operation, otherwise, no matter how good the quality of the lifting belt is, it will not help. So what problems do hoisting belts have nothing to do with quality? How should we correctly use the lifting belt? Two cases have nothing to do with the quality of the lifting belt itself. One is that the lifting belt is cut off due to repeated friction when lifting equipment with sharp edges and corners; the other is that there is serious overload in the process of lifting and the lifting belt is pulled off. Both of these situations are caused by the absence of rules. It has nothing to do with the quality of the lifting belt.
What we need to do is to avoid using lifting belt to lift equipment with sharp edges and corners as far as possible. If it is a special case, we can increase the protective sleeve of lifting belt at the contact point of lifting belt and edges and corners to reduce the wear between them. It is also necessary to carry out lifting operations within the rated load of the lifting belt.