Lifting belt is more prevalent in the sling, hoisting industry has a good load capacity and ductility, and how deal with quality problems about hoisting belt, many say directly scrap processing, actually this kind of mindless way of disposal is not entirely correct, if to consider from economic Angle, we can to downgrade its processing.
May be many people do not understand, what is degraded? To what extent can hoisting be degraded? To what extent can scrap be taken? About these questions, Chenghua manufacturing will bring you detailed answers. First of all, let's first understand the scrapping treatment of lifting belt. Lifting with transverse edge cutting, serious distortion and flapping, local scratches or scratches by sharp objects, and lifting with body cuts, loose band should be immediately scrapped. Then there is the downgrade. We need to know that the downgrade means that the lifting belt still has the use value, but the value has been reduced, and it no longer has the previous lifting capacity. When the surface of the flat lifting belt is worn and the wire is not broken, it should be degraded and used, but if there is only one fracture surface reaching 1/4 of the bandwidth, it should be scrapped.
It is also necessary to pay special attention to that the lifting belt used for downgrade should be covered with the original label and re-marked with its rated lifting weight and length, etc., and be re-classified and stored on the corresponding tool rack as required to avoid unnecessary losses caused by mistake.