Lifting belt is a very important sling in lifting operation, and the quality of lifting belt directly determines the safety of lifting operation, so the daily detection of lifting belt is particularly important. Once the lifting belt reaches the scrap condition after detection, it will immediately stop using.
But in many cases, some lifting belts are slightly damaged, but they have not reached the scrap condition, so what should we do for this kind of lifting belt? Here is a brief analysis. First, we need to judge according to the damage degree of the surface of the lifting belt. If there is only slight fracture of single wire or jumper wire, we can repair it, but it needs to be noted that the wire used for repair must be the same as the material of the lifting belt. Second, if the broken part of the lifting belt is obvious, it can still be mended in order to be scrapped. However, the rated load of the lifting belt after mending must be greatly reduced. For the sake of safety, it can be used for binding and fixing operations.
In short, the daily detection of the lifting belt can not be omitted. In the detection project, no matter what degree of damage the lifting belt appears, we need to pay attention to it and store it by classification, so as to avoid accidents caused by mistake in the next use.